Page | 4
User Interface Display and Button Functions Cont.
3
.
F1 Button
Press and hold the
F1
button until [
“P”] shows on the display. When the button is
released [ON]* will show on the display.
Continue to press
F1
to scroll through the various set up functions.
Whenever a function is changed, press and hold
F1
until the buzzer sounds twice
to save the change**
* If the counter is turned off, [OFF] will appear on the display.
** If the buzzer has been disabled it will not sound.
4.
F2 and F3 Buttons
Use these buttons to change the values in the Set Up Function. Some values are
limited depending on the function being set.
Press and hold the F2 button until [ r 0] is displayed and the Pass/Fail lights blink.
This will put the tool in the joint learning mode.
5. Pass LED***
When the fastener is driven properly the Green LED is lit.
6. Fail LED***
When the fastener is not driven properly the Red LED is lit.
***
The LED will remain on until the trigger is operated again.
Quick Start Procedure
Important! Before actually learning the joint, drive 1 or 2 fasteners to
“exercise” the tool
and set up the starting position of the clutch.
1.
Press and hold the
F2
button until [r 0] is seen on the display and both the Pass &
Fail LEDs blink.
