VR209TP
10
Source Select Menu
Touch to select a playback source from the “Source Select” screen:
Display Setup Menu
The following “Display Setup” options can be adjusted:
System Setup Menu
The following “System Setup” options can be adjusted:
Trigger Delay
1 SEC
Set delay time for displaying camera image after trigger
signal is removed.
2 SEC
3 SEC
4 SEC (default)
5 SEC
6 SEC
Auto Mic Trigger
MIC 1
Select microphone to be used for rear camera.
MIC 2
Reset
Off (default)
Select "On" to restore camera factory settings.
On
Table 4: Display Setup Menu Options
Setting
Default
Options
Function
Dimming Day
07
00-10
Adjust display lighting level for day and night
viewing.
Dimming Night
02
00-05
Table 3: Camera Setup Menu Options
Setting
Options
Function
AM
WB
SAT
CD
USB
iPod
F.AUX
R.AUX
S o u r c e S e l e c t
Table 5: System Setup Menu Options
Setting
Options
Function
Beep Tone
Off (default)
Select “On” to hear audible confirmation when pushing
front panel buttons.
On
Radio
USA (default)
Select the appropriate setting based on the country in
which you reside.
Europe
Clock Format
12 Hr (default)
Clock displays in 12 hour mode with AM and PM.
24 Hr
Clock displays in 24 hour mode up to 23:59
Clock
(HH:MM)
See “Adjusting the Clock” on page 7 to learn how to set
the clock.
Time Zone
New Foundland
Only available in Sirius mode. Set correct time zone for
correct time.
Atlantic
Eastern
Central (default)
Mountain
Pacific
DST Mode
Observed (default)
Only available in Sirius mode. Set for Daylight Savings
Time.
Not Observed
WB Alert
On
Turn the WB alert function On/Off.
Off (default)
iPod Auto Detect On (default)
Turn the iPod auto detect function On/Off.
Off
Alert Power
Off (default)
Select “On” to have the radio automatically turn on
when a weather alert is received.
On
P-Volume
Off - 40 (off is the
default value)
When set to “Off”, the radio will turn on at the same
volume level set when it was last turned off. Otherwise,
you can choose a default turn-on level between 1 ~ 40.
TS Calibrate
No (default)
Select "Yes" to calibrate the touch screen
Yes
NOTE: For proper calibration you must touch each pointer for 2 seconds. If
pointers are not touched properly, the calibration sequence will start over until
the calibration is done correctly.
Factory Default
No (default)
Select “Yes” to restore factory default settings for the
System Setup menu options.
Yes
