E-11
RADIO OPERATION
1.
Tap the
POWER/STANDBY
Button
on main unit or remote control to turn on the unit.
2.
Tap the
MODE Button
on main unit or remote control to select FM/AM mode, the FM/AM
radio frequency appear in display.
3.
To manually tune to a specific radio station, tap the
TUNE
or
Button
on either main
unit or remote control repeatedly. Use the manual tuning method to tune in weaker stations
that are bypassed during Automatic Tuning.
4.
To automatically tune to the next available radio station, press and hold the
or
Button
on main unit or remote control for 1-2 seconds until frequency readout on the display
begins to scan and then release the button. The tuner will stop scanning when it receives the
next broadcasting station of adequate signal strength.
5.
Press the volume control on main unit or remote control to adjust the volume control to the
desired volume level.
FM / FM Stereo reception
When listening to the FM radio, press the
ST./MONO Button
on remote control to switch
between stereo mode and mono mode. The FM stereo icon “ST” will appear on the display if
unit is in stereo mode. It is preferable to receive the program in mono when you are receiving a
weak station.
HINTS FOR BEST RECEPTION:
AM -
The AM antenna is located inside the cabinet of the unit. If AM reception is weak,
change the position of unit until the internal antenna picks up the strongest signal.
FM -
For best FM reception, the FM lead wire antenna located on the back of the unit
should be fully unwrapped and extended.
NOTE:
Automatic tuning depends on the signal strength of the broadcasting station, so weak
stations may be skipped. You can manually tune to find the weak stations if a station gets
skipped. With strong signals, the tuner may stop before it reaches the actual broadcast
frequency, so you may need to manually tune for the best reception.
PRESET RADIO STATIONS
1.
Press the
Button
on main unit or remote control to turn on the unit.
2.
Tap the
MODE Button
on main unit or remote control to select FM radio mode.
3.
Press and hold the
PLAY/PAUSE
button on main unit or remote control until frequency
readout on the display begins to scan and then release the button for auto search and
program preset channels. “PROG” appears in display and flashing. Auto searching and
program will stop at P01 after scan finished, “PROG” shows in display steadily.
Note:
If the channels stored during the auto search & programmed preset are not ones you
want saved, use the method below for the manually saving radio presets.
4.
Tune to the desired radio station either by “manually” or “automatically” tuning method.
5.
Tap the
MEM. Button
on main unit or remote control, the next available preset memory
number and a flashing “PROG” icon will show in the LCD display. (Note:”P01” will show in the
display if you are programming preset for first time)
6.
Tap the
PRESET
+/-
Button
on main unit or remote control to select the preset number you
want to assign the station to.
7.
Tap the
MEM. Button
to confirm the setting.
8.
Repeat above steps 4 - 8 to preset up to 30 FM and 20 AM stations.
RECALLING PRESET MEMORY CHANNELS
In radio mode, recall the pre-set channels by pressing the
PRESET
+/-
Button
on main unit or
remote control repeatedly.