E-9
Battery Precautions
Replacement of batteries must be done by an adult.
The supply terminals are not to be short-circuited.
Non-rechargeable batteries are not to be recharged.
Exhausted batteries are to be removed.
Only batteries of the equivalent type are to be used.
Batteries are to be inserted with the correct polarity.
Dispose of batteries properly. Do not dispose of batteries in fire. The batteries may
explode or leak.
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
The remote control supplied with this product contains a coin/button cell
battery. If the coin/button cell battery is swallowed, it can cause severe
internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment
does not close securely, stop using the product and keep it away from
children.
If you think batteries might have been swallowed or placed inside any part of
the body, seek immediate medical attention.
NOTE ON NON-MAGNETICALLY SHIELDED SPEAKERS
This unit is not magnetically shielded and may cause color distortion on the screen of some TVs or
video monitors. To avoid this, you may need to move the unit further away from the TV or monitor
if unnatural color shifts or image distortion occurs.
TURNING THE UNIT ON/OFF
1. In Off (standby) mode, tap the
POWER/STANDBY
Button
on main unit or remote control to
turn the unit ON. The unit will turn on, the last selected input mode icon will show on LCD
display.
2. To turn the unit OFF (standby), tap the
Button
on main unit or remote control again. The
LCD DISPLAY
will go dim and show the current time. The standby mode indicator lights.
SETTING THE CLOCK
After plugging in the AC power, “12:00” will appear and start blinking on the LCD display.
1. In Power Off (Standby) mode, press and hold the
TIME SET Button
on remote control or main
unit, the 12 HOUR format “12H” will show in display.
2. Tap the
or
Button
on remote control or main unit to select 24 Hour format if
necessary. Otherwise, press the
TIME SET Button
to confirm 12 Hour clock format and enter
clock setup mode, Hour digits will be flashing.
3. Tap the
or
Button
on remote control or main unit to adjust the hour. Press and hold
the button for fast advance / reverse setting.
Note:
Make sure the hour is set so that the
PM
indicator is displayed correctly.
4. Press the
TIME SET Button
on remote control to confirm the hour setting, the minute digits will
flash to prompt for input.
5. Tap the
or
Button
on remote control or main unit to adjust the minute. Press and hold
the button for fast advance / reverse setting.
6. Press the
TIME SET Button
on remote control again to complete the setting.
NOTE:
The clock and radio station presets will need to be reset if the power is interrupted or in the
event of a power outage. “12:00” will appear and start blinking on the LCD display to notify
you that the power was interrupted and the clock will need to be reset. Please follow steps
1-6 above to reset the clock.
