Jensen A141 XL ZKX, Руководство по эксплуатации

Страница: 58 / 128

42
6. Maintenance
6.4. Locking torque for bolted assemblies
Attention
!
All bolted assemblies especially of the knife and of the chassis should be checked
regularly, retighten if necessary. Unless otherwise noted the following locking torques
apply.
thread
locking torque
8.8 (Nm) locking torque
10.9 (Nm)
M6
10 14,5
M8
25 35
M10
49 72
M12
86 125
M16
210 310
M20
410 610
M24
710 1050
¾“
410
6.5. Maintenance of the cutting tools
Blunt knifes can affect the quality of the wood chips negatively.
If necessary the cutting tools can be re-sharpened or changed.
Important!
1. Block the knife disk with the provided blocking tool before changing the knives.
Use the bolts of the ejector cap (see picture).
2. Always keep the cutting unit in a sharp condition to guarantee an efficient and
slightly cut.
3. Do not grab the knife on the blade side –
Danger of injury
!
4.
Attention!
Excessive wear out of the cutting unit can cause a total loss of the
cutting unit.
5. Pay attention for the operating condition: the condition of the material can
affect the durability of the cutting tools (clean fresh wood or with abrasive
materials attached material).
Knife disk blocking tool schematic display, differences in design and type possible.