ELECTRICAL REQUIREMENTS
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your double drawer into its
fi
nal
location, it is important to make sure you have the
proper electrical connection.
RECOMMENDED GROUNDING METHOD:
A 115 V, 60 Hz, AC only, 15 A or 20 A fused, grounded
electrical supply is required. It is recommended that
a separate circuit serving only your double drawer be
provided.
Use an outlet that cannot be turned off by a switch.
Do not use an extension cord.
NOTE:
Before performing any type of installation,
cleaning, or removing a light bulb, unplug the double
drawer or disconnect power.
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
REMOVE THE PACKAGING:
Before using your double drawer, all packaging materials
should be removed and the interior should be cleaned.
Remove tape and glue residue from surfaces before
turning on the double drawer. With your
fi
ngers, rub
a small amount of liquid dish soap over any adhesive
and wipe with warm water to remove.
Do not use sharp instruments, rubbing alcohol,
fl
ammable
fl
uids, or abrasive cleaners to remove tape
or glue. These can damage the surfaces of your double
drawer. For more information, refer “Double Drawer
Safety” section.
Dispose of and/or recycle all packaging materials.
After all packaging materials have been removed,
clean the inside of your double drawer the cleaning
instructions in “Cleaning” section.
9
INSTALLATION INSTRUCTIONS
UNPACK THE REFRIGERATOR DRAWERS
CLEAN BEFORE USING:
After you remove all of the package materials, clean the
inside of your refrigerator drawers before using them.
See “Cleaning.”
WATER SUPPLY REQUIREMENTS
(
REFRIGERATOR
/
FREEZER DRAWERS ONLY
)
Gather the required tools and parts before starting
installation. Read and follow the instructions provided
with any tools listed here.
IMPORTANT:
Connect to potable water supply.
When Moving Your Refrigerator Drawers:
Your refrigerator drawers are heavy. When moving the
appliance for service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always
pull the appliance straight out when moving it. Do not
wiggle or “walk” the appliance when trying to move it,
as floor damage could occur.
If you turn ON the refrigerator before the water line is
connected, turn OFF the ice maker.
All installations must meet local plumbing code
requirements.
Use copper tubing and check for leaks. Install copper
tubing only in areas where the household temperatures
will remain above freezing.
TOOLS NEEDED:
Flat-blade screwdriver, 7/16” and 1/2” open-end wrenches
or two adjustable wrenches, 1/4” nut driver and drill bit,
cordless drill.
NOTE:
Your refrigerator dealer has a kit available with a
1/4” (6.35 mm) saddle-type shutoff valve, a union, and
copper tubing. Before purchasing, make sure a saddle-
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst
reduction may be used on disinfected waters that may
contain filterable cysts.
Содержание JUCFP242HL11
Страница 2: ......
