Jenn-Air JUCFP242HL11, Руководство пользователя

Страница: 12 / 60

A
A- Check the level
from left to right.
3.
Remove the level and close the top drawer. Check the
gap between the top of the drawer and the
countertop. If the gap measures less than 3/8” (0.95
cm) minimum, turn all four leveling bolts equally to
the left to raise the leveling legs (this will lower the
appliance). Recheck the level.
4.
Open both drawers less than midway. Place the level
on the side flange beside the drawers as shown.
A
A- Check the level
from front to back.
5.
Remove the level and close the drawers. Recheck the
gap between the top of the drawer and the
countertop. If the gap measures less than 3/8” (0.95
cm), turn all four leveling bolts equally to raise the
leveling legs (this will lower the appliance). Recheck
the level.
NOTE: Be sure to recheck the horizontal level of the
top drawer.
6.
Be sure all four levelers are on the floor and
supporting the full weight of the refrigerator drawers.
2.
Turn the leveling legs (front and back) until the top
drawer measures level from left to right. COMPLETE INSTALLATION
1.
Remove all boxes, parts packages and packing
materials from the interior of the refrigerator drawers.
2.
Remove the film.
3.
Clean the refrigerator drawers before use.
4.
The controls are preset at the factory to the
recommended settings. Be sure that the compressor
is operating properly and that all the lights are
working.
5.
If construction will continue after the refrigerator
drawers have been installed, turn OFF the power for
both drawers.
To get the most efficient use from your new refrigerator
drawers, read the “Refrigerator Drawers Use” section.
12
LEVEL THE REFRIGERATOR DRAWERS
IMPORTANT:
Overlay Model-Be sure to install the custom overlay
drawer panels before leveling the refrigerator drawers.
See “Install Custom Overlay Drawer Panels.”
Before installing the refrigerator drawers, be sure that
the countertop is level.
If the countertop is not level, adjust the refrigerator
drawers’ leveling legs until the appliance is square with
the countertop. Be sure to maintain 3/8” (0.95 cm)
minimum gap between the top of the drawer and the
countertop.
1.
Open the top drawer and place the level across the
top drawer, as shown. Check the level from left to
right.
Turn the front leveling bolts together in order to
either raise or lower the appliance until the sides of
the refrigerator drawers are plumb.