Jenn-Air 720-0727, Инструкция по установке и руководство по эксплуатации и уходу

Страница: 18 / 120

18
Low Flame Adjustment
If flame goes out on the “LO” setting, the low flame setting must
be adjusted.
1. Turn off the valve and wait until grill and burners are cool.
2. Remove grill grates and flame tamers.
3. Light grill using information in the “Outdoor Grill Use” section.
4. Turn burner to its lowest setting.
5. Remove each control knob for the main burners and side
burner by loosening the setscrew with the Allen key.
6. Hold valve stem with pliers and insert a small flat-blade
screwdriver into the shaft.
7. Watch the flame and slowly turn the screwdriver
counterclockwise.
8. Adjust flame to minimum stable flame.
9. Replace the control knob and turn off the burner.
10. Repeat steps 3 through 9 for each burner if needed.
11. Replace the flame tamers and grates after the burners have
cooled.
Check Operation of Oven Burner
1. Open oven door.
2. Press in and turn the oven control knob to 350°F.
■
The oven burner should light in 20-40 seconds; this delay
is normal. The oven valve requires a certain time before it
will open and allow gas to flow.
To avoid damaging the hot surface igniter, do not insert any
object into the openings of the shield that surrounds the
igniter. Do not clean that area.
3. Check the oven burner for proper flame. The flame should be
½" (0.13 cm) long, with inner cone of bluish-green. The outer
mantle should be dark blue and should be clean and soft in
character. No yellow tips (not enough air), blowing or lifting
(too much air) of flame should occur.
If the flame needs adjusting:
1. Turn the oven off. Wait for the oven burner to cool down.
2. Open oven door and remove oven racks. Remove oven
bottom cover by lifting up and out. Set oven racks and oven
bottom cover aside.
3. Remove flame spreader and set aside.
4. Locate the air shutter near the rear wall of oven and loosen
the shutter screw.
5. Adjust the air shutter.
6. Turn the oven back on and check for proper flame. If the
flame is still not properly adjusted, turn the oven off, wait for
the oven burner to cool down and repeat Step 4 until flame is
properly adjusted.
7. When the flame has been properly adjusted, turn the oven off,
wait for the burner to cool down.
8. Tighten the shutter screw.
9. Reinstall flame spreader and oven bottom cover. Reinstall the
oven racks.
10. Close the oven door.
A. Valve stem
B. Small flat-blade screwdriver
C. Pliers
A
B
C
A. Oven bottom cover
A. Screws
B. Flame spreader
A. Shutter screw
B. Air shutter
1
2
A
A
B
A
B