14
3.
Connect the quick connector on the other end of the
10 ft (3.0 m) PVC flexible gas supply hose to the rigid Natural
gas supply pipe. To use the quick connect fitting; pull the head
of the quick connect back, insert the end of the PVC gas hose
and release the head of the connector. Check the the
connection is secure.
Change Grill Burner Valve Orifices
1. Remove the grates and flame tamers.
2.
Remove the 1 screw and 1 cotter clip that hold the burner in
place. Set the screws aside. Remove the burner from the grill
by lifting the burner out
.
3.
Use a 6 mm socket and wrench or 6 mm nut driver to remove
the brass orifice from the end of gas valve. The main burner
orifice is located behind the LP orifice, so no additional orifice
needs to be installed.
IMPORTANT: Check that the orifice is properly installed inside
of the burner opening.
4. Reinsert the burner and reattach using the 1 screw and 1
cotter clip previously removed. Repeat the procedure for each
main burner.
5. Position the igniters so they are ¼" (6.0 mm) away from each
burner.
Change the Rotisserie/Infrared Burner Orifice
1.
Using a Phillips screwdriver, unscrew the 2 screws and
remove the rotisserie/infrared burner wind baffle
.
A. 10 ft. (3.0 m) PVC gas hose
B. Natural gas pressure regulator/hose assembly
C. Manifold
D. Right side panel
A. Screw
B. Cotter Clip
A
B
C
D
A
B
A
A. Main burner orifice
A. Wind baffle
A
A