JENCONS Powerpette, Инструкция для оператора

Страница: 6 / 36

4
OPERATOR
Instructions
Recharging the
POWERPE TTE
/
POWERPE TTE
Plus
/
POWERPE TTE
Before starting to operate, carefully check mains voltage and recharge batteries.
To charge the
POWERPE TTE
/
POWERPE TTE
Plus
/
POWERPE TTE
1 Recharging tempe10°C to +35°C.
2 Plug the charger jack (6) into the base of the
POWERPE TTE.
3 Plug the charger (5) into a suitable wall socket. The red indicator on the charger will light up.
4 Place
POWERPE TTE
onto bench stand.
5 Allow unit to charge for 14 hours from empty to fully charged.
6 Once the
POWERPE TTE
is fully charged, the charger automatically switches to a trickle
charge operation and the red indicator will turn off. If the charge to the POWERPE TTE is
interrupted and then re - started, the charger starts its full 14 hour charging cycle again.
This will not damage the battery.
Only use the charger indoors and protect against moisture.
Fitting the
POWERPE TTE
wall bracket
The
POWERPE TTE
wall bracket can be attached by removing the adhesive protective film
from the double sided tape and pressing firmly to a grease free smooth surface. Alternatively,
it can be attached using the two stainless steel screws provided. Care should be taken in
positioning the screws.
Fitting the
POWERPE TTE
Plus
/
POWERPE TTE
into the bench stand
The
POWERPE TTE
Plus
/
POWERPE TTE
can be fitted in the bench stand in one
of the two positions shown. It can be charged in either position.