JENCONS Powerpette, Инструкция для оператора

Страница: 3 / 36

1
OPERATOR
Instructions
Introduction
The Jencons
POWERPE TTE
,
POWERPE TTE
Plus
and
POWERPE TTE
have
been carefully designed and manufactured as lightweight, cordless pipetting aids for use with all
plastic or glass pipettes from 1– 100ml.
These new
POWERPE TTES
are constructed in recyclable materials and operate on two
rechargeable, long life, environmentally friendly, 1.2V nickel metal hydride batteries.
POWERPE TTES have uniquely formed finger triggers to minimize any high pressure points.
These triggers also control intake and dispense speeds.
A battery warning light (4) is triggered whenever the charge in the batteries is low and they
should then be recharged. Pipetting with
POWERPE TTES can also take place while the units
are connected to their chargers (5).
POWERPE TTES
have a conveniently located slide switch (3) which allows the user to select
between three modes of operation:
Slide switch position ‘High’ (top) Suction and dispense at full speed (Blow-out)
Slide switch position ‘Low’ (middle) Suction and dispense at reduced speed (Blow-out)
Slide switch position ‘G’ (bottom) Suction at reduced speed, dispense by gravity (To Deliver)
Technical Data
Batteries 2 x 1.2V nickel metal hydride
Battery service Life 500 – 1000 cycles from empty
Charger 75m A /h for 14 hours plug-in; UK, European, USA, Indian,
Japanese or Australian versions
Installation (over voltage) category II
Double insulation indicated on charger by symbol
Overall weight 180 g without stand
Filter (8) Hydrophobic 25 mm dia 0.45 µm (fitted) plus two
additional spare filters
1x 0.45 µm
1x 0.20 µm
Manifold material ABS
Case material ASA
Nosecone material Polypropylene (10)
Pipette holder Silicone (9)
Pipette types Plastic or glass 1 – 100 ml