Jema JM-988, Руководство пользователя

Страница: 7 / 18

9.Main buttons & Vice buttons set : Large number of buttons for Main buttons through to the vibrate plate for feed.
Little number of buttons for vice buttons by manual feed.Before start,set the main buttons and vice buttons quantity.
Vice buttons set “0” means only one type buttons for work.(Fig.9)
7.Press the key “Manually Feeding button”, check whether the specifications of button gripper base are
appropriate, and replace it if the specifications are not appropriate.
8.Press the key “Manual testing” and then “Stretching out and drawing back of damper”. Stretch out the gate, and
adjust the gap between buttons to be 0.2-0.5MM.
6
10.Pressing buttons area
Rubber nozzle Front guide block
Front guide block
Fig.(1)
Rubber nozzle
Fig.(2)
Rubber nozzle
Fig.(3)
Fig.4 Fig.5
1.Original machine installed (1)Front guide block & (2)Rubber nozzle
2.Accessory packing with (1)Front guide block & (3)Rubber nozzle
3.Important note
：
(2)Suitable for buttons size less than 15mm
(3)Suitable for buttons size over than 15mm or convex buttons
4.Suggestion collocation of above, please following the actual situations to change different size of front guide
block and rubber nozzle.
In order to press buttons stability and smoothly on the pin plate, plz use correct demensions of the pin plate for
buttons when replace the pin plate. (Important note. its the best size for the pin plate if all pins in the middle center
position of the button’s hole)
5.Loosen J10 throttling valve to increase the cylinder pressure, meanwhile, the pressing button motor will rise at a
higher speed, but the tightened cylinder pressure is decreased and pressing button motor rises at a slower pace.Fig4 5
6.Pressure control for the spring: For thin buttons, clockwise rotating the spring ,spring’s pressure became bigger.
For thick buttons ,anticlockwise rotating the spring, spring’s pressure became small. Important note : All based on
press buttons smoothly , stability, lower noisy as the standard.(Fig.6)
(
6
)
11.Press the key “Resetting” to restore the machine to initial state.