Jema Autolifte DWC-9-E, Руководство по эксплуатации

Страница: 27 / 38

6.5 Changing of threshold
Press the button on the keyboard. A pointer ( < ) will appear on the display on the
side of the Q pictogram. The wheel balancer has four threshold values: 0, 2, 5
and 10 grams. Pressing either or the value of threshold is increased or decreased,
respectively. Setting the threshold results in displaying "0" in a situation where the
measurement result is less or equal the selected threshold.
6.6 Input of parameter values
Inputting the above mentioned parameters can be done in three different ways:
1. using saved data in one of four memory banks - see chapter 6.7.1
2. Setting values and configuring ALU using
and keys - (by hand)
3. Setting Q and ALU with U or buttons and using
the active adjuster.
Adjuster is a tool for automatic inputting after pressing
^^^or keys, for distance and diameter parameters, and even width for weight
placement modes
(3)
and (4). Independent of whether the weight on the left imbalance
plane is hammered or glued - the head of the adjuster is to be placed on the desired weight
placement position. For hammered weights it should be placed on the edge of the rim as
presented in fig. 6.1(a), whereas with adhesive weights on the side, as presented in
eg. «л® , and wait for the signal informing of simultaneously changing parameters
and
in the machine's memory.
ATTENTION! During diameter measurement, for some wheels, the result may differ
from the NOMINAL diameter (+/-0.5"). This does not affect imbalance measurement in
any way since the real value is taken into account, measured with the adjuster.
Fig. 6.1 Positioning of the adjuster's head
(a)
for hammered weights
(g)
for adhesive weights
(D
- adjuster's head (2) -
edge of the rim
-
27
-