Jegs 81026, Руководство по установке

Страница: 7 / 10

Priming Instructions
Notice: Always open vent valve when replacing cartridge. This will allow air to escape from
cartridge and prime grease gun.
Notice: Remove air pocket! Air pocket in the cartridge will prevent grease from being
pumped and cause the grease gun to lose its prime. Unscrew the vent valve several times to
remove small air pockets trapped in this area.
Install a Grease Cartridge
1. Unscrew the grease tube assemble from the cordless grease gun.
2. Pull back on the follower handle until the follower rod is fully extended and latch the
follower rod groove into the slot on the tube end cap of the grease tube.
3. Remove the plastic cap from the grease cartridge and insert cartridge into the container
tube.
4. Remove the pull tab from grease cartridge and screw grease tube into cordless grease
gun assembly.
5. Release follower rod from slot to allow it to go forward. Purge air from assembly. See air
purging instruction.
Notice: Reset display reading after purging air.
1-800-345-4545 jegs.com