JDW ZQ562, Инструкция по эксплуатации

Страница: 20 / 24

19
Trimming (See Fig. 23)
Position the trimmer head as shown for trimming.
Keep the bottom of the trimmer head just above the ground and
at an angle.
Allow only the tip of plastic cutting blade to make contact. Do not
force plastic cutting blade into work area.
Cutting Blade Replacement(See Fig 24, 25)
There are 10 spare cutting blades included. When you
change the blade, you must use the original type of blade .
WARNING! Periodically inspect the blade adapter for cracks,
especially if you strike a foreign object. Replace when necessary.
1. Turn the head of grass trimmer over so you can see the
plastic cutting blade (g) and blade holder (h). The blades have
a keyhole shaped slot as shown in (See Fig 24). To remove a
blade, please push it towards the larger end of the keyhole slot
(See Fig 24) and then pull the blade upwards (See Fig 25). You
will need to push the blade quite hard before it moves.
2. Before fitting a new blade, clean the blade holder pegs.
To fit a new blade, place the larger end of the keyhole slot over
the blade holder peg and then pull the blade outwards until the
peg is fitted into the smaller end of the keyhole slot. You will
need to pull the blade quite hard before it moves.
3. Ensure the blades are secure before using.
NOTE: The blade will only fit in one direction; do not attempt to
fit the blade in the wrong direction.
WARNING! Do not touch the rotating blades. Please take care
when handling.