JDS Uniphase PathTrak HCU200, Инструкция по установке и эксплуатации

Страница: 13 / 22

Section 2: HCU200 Unpacking and Setup
6
PathTrak™ HCU200 Install User’s Guide Rev. 000
Figure 10 IP Address in Edit Mode
13 Use the up or down arrow keys to set the first
number of the first IP address octet (range blank
thru 2). If the first octet is less than 100, scroll until
the digit is blank. Once the first number is set, use
the right arrow key to move the cursor to the second
number of the first IP address octet (
Figure 11 ).
Figure 11 IP Address in Edit Mode (1st Octet)
14 Use the up or down arrow keys to set this number to
the proper value (range 0 thru 9). Once this
number is set, use the right arrow to move the
cursor to the next digit.
15 Follow the same process until the correct IP
address shows on the display and then press
"Enter". This will save the address information and
place the unit back in normal operation mode.
16 Now, press the down arrow to go to the subnet
mask field and repeat the process used to set the IP
address. When the subnet mask is correct, press
the down arrow and repeat once more for the
default gateway.