Jconcepts BJ4, Руководство пользователя

Страница: 12 / 39

LONG STEERING
BELLCRANK
x 1
SHORT STEERING
BELLCRANK
x 1
1/8 x 1/4
BEARING
x 4
STEERING AND TOP DECK COMPONENTS
STEERING
BUSHING
x 2
STEERING POST
x 2
4-40 MINI
LOCKNUT
x 8
FRONT BODY
MOUNT
x 2
ANTENNA
MOUNT
x 1
FRONT TOWER
MOUNT
x 1
4-40 x 5/16"
FLAT HEAD
x 4
4-40 x 1/4"
BUTTON HEAD
x 4
4-40 x 5/16"
BUTTON HEAD
x 2
TRANSMISSION
SPACER
x 2
LONG
BALL END
x 6
SHORT
BALL END
x 1
4-40 x 3/8"
FLAT HEAD
x 9
4-40 x 3/8"
BUTTON HEAD
x 1
4-40 x 1/2"
FLAT HEAD
x 2
.030" NYLON
WASHER
x 2
REAR TOWER
MOUNT
x 1
.030" ALUMINUM
WASHER
x 11
STEERING ASSEMBLY:
4-40 x 1/4"
FLAT HEAD
x 4
2-56 x 5/16"
BUTTON HEAD
x 2
1. THREAD BOTH STEERING POSTS INTO THE STEERING BELLCRANKS AS SHOWN.
PAY ATTENTION TO THE ANGLE ON THE LONG BELLCRANK. THE LONG SIDE OF
THE BELLCRANK SHOULD ANGLE AWAY FROM THE CENTER OF THE ASSEMBLY.
(APPLY A SMALL AMOUNT OF THREAD LOCKING COMPOUND)
2. SLIDE ONE .030" NYLON WASHER ONTO THE TOP OF EACH STEERING POST.
3. SLIDE ONE .030" ALUMINUM WASHER ON TO A SHORT BALL END AND
FASTEN IT TO THE LONG BELLCRANK AS SHOWN.
(APPLY A SMALL AMOUNT OF THREAD LOCKING COMPOUND)
4. SLIDE THREE .030" ALUMINUM WASHERS ONTO A LONG BALL END.
INSERT THE BALL END WITH THE THREE WASHERS INTO THE BACK
HOLE OF THE GRAPHITE STEERING RACK (THE FLAT EDGE OF
THE STEERING RACK IS THE BACK EDGE). SECURE THE BALL
END WITH ONE 4-40 MINI LOCKNUT. REPEAT FOR OTHER SIDE.
5. INSERT A STEERING BUSHING INTO THE GRAPHITE STEERING RACK
(NOTE DIRECTION). SLIDE ONE 4-40 x 5/16" BUTTON HEAD SCREW
UP THROUGH THE BOTTOM OF THE RACK AND TIGHTEN THE SCREW
INTO THE BELLCRANK. REPEAT FOR OTHER SIDE.
(APPLY A SMALL AMOUNT OF THREAD LOCKING COMPOUND)
BODY MOUNT
PAD
x 2
APPLY A SMALL
AMOUNT OF
THREAD LOCKING
COMPOUND
NYLON
NOTE DIRECTION
APPLY A SMALL AMOUNT OF
THREAD LOCKING COMPOUND
BAG D
STEP 1
PAGE 11