Jconcepts BJ4, Руководство пользователя

Страница: 18 / 39

LONG BLACK
BALL END
x 2
REAR A-ARM
LEFT & RIGHT
x 1 EACH
REAR END COMPONENTS
HUB CARRIER
LEFT & RIGHT
x 1 EACH
2-56 x 1/8"
BUTTON HEAD
x 2
HINGE PIN 1.O6"
(REAR OUTER) x 2
TITANIUM TURNBUCKLE
2.00" (CAMBER) x 2
.030 NYLON
WASHER
x 4
4-40 MINI
LOCKNUT
x 2
HINGE PIN 2.00"
(REAR INNER) x 2
BEARING
SPACER
x 2
HUB CARRIER ASSEMBLY:
1. SLIDE TWO SMALL AXLE SHIMS AND ONE 3/16 x 3/8
BEARING ONTO THE CVD AXLE. SLIDE THE AXLE
ASSEMBLY INTO THE BACK OF THE HUB CARRIER.
2. IN ORDER, SLIDE A BEARING SPACER, 3/16 x 3/8
BEARING, AND ONE THICK AXLE SHIM ONTO THE
CVD AXLE.
3. PRESS THE BEARING INTO THE HUB CARRIER AND
INSERT A ROLL PIN INTO THE AXLE.
4. PARTIALLY THREAD A REAR WHEEL NUT ON THE AXLE.
5. THREAD ONE LONG BLACK BALL END INTO THE MIDDLE
HOLE ON THE HUB CARRIER. SECURE IT USING ONE 4-40
MINI LOCKNUT. REFER TO ILLUSTRATION FOR LOCATION.
6. REPEAT FOR THE OPPOSITE ASSEMBLY.
ATTENTION!
LONG BLACK
BALL END
THIN AXLE SHIMS
x 2
ROLL PIN
THIS IS A LEFT SIDE ASSEMBLY ILLUSTRATION, NOTE
DIRECTION AND CONFIGURATION OF HUB CARRIER
3/16 x 3/8
BEARING
x 2
1.30
FRONT CAMBER TURNBUCKLE 2.00": x 2
SCALE 1:1
1. TWIST THE BALL CUPS ON TO EACH BLUE TITANIUM TURNBUCKLE
UNTIL YOU GET THE DIMENSION SHOWN FOR EACH PART.
2. LOCATE THE NOTCH ON EACH TURNBUCKLE AND ROTATE
THEM SO THAT IT IS LOCATED ON THE OUTSIDE OF THE CAR
ON THE LEFT AND THE INSIDE ON THE RIGHT. SNAP ALL OF
THE FRONT TURNBUCKLES INTO PLACE WHERE SHOWN.
MAKE SURE THAT ALL OF THE CVD BONES ARE IN THE SLOTS
OF THE OUTDRIVE HUBS.
FRONT TURNBUCKLE ASSEMBLY:
1.00
FRONT STEERING TURNBUCKLE 1.775": x 2
SCALE 1:1
STEERING
TURNBUCKLE
CAMBER
TURNBUCKLE
STEP 4
BAG F
STEP 1
PAGE 17