(Continued )
WBA
TM
- DT-004 Downloading
Using the JCM DT-004 Download Tool
DO NOT USE the 2-pin connector for power input.
This is output power and can damage the DT-004.
1. Make sure power is applied to the DT-004 via a 3-pin connector
from the PS15-007 power supply with the adaptive harness, Part
No. 400-100067, or the power supply harness connection in the
game.
2. With the power “OFF”, be sure the 4MEG Program EPROM is
installed properly.
3. Dip switches on WBA:
Set Dip switches 6, 7, and 8 to the “ON” position, and all others to
the “Off” position.
4. Harnessing
•
For WBA-10/20: Use Part No. 400-10068 (Power from game to
DT-004), Part No. 400-100069 (Data from DT-004 to WBA
unit).
Note: The PS15-007 can be used to substitute for a power source
instead of using the harness, Part No. 400-100068 at the game.
When there is an RS-232 board, disconnect the board and use
the harness, Part No. 400-100042 in conjunction with harness,
Part No. 400-100069
•
For WBA-12/22: Use Part No. 400-100070 (Power from game
to DT-004), Part No. 400-100071 (Data from DT-004 to WBA
unit).
Note: The PS15-007 can be used to substitute for a power source
instead of using the harness, Part No. 400-100070 at the game.
When there is an RS-232 board, the WBA-12/22 can be flashed
through the RS-232 board using the harness, Part No. 400-
100071.
5. Turn the power switch on the DT-004 to the “ON” position. The
Power LED should light.
6. Verify the LEDs on the WBA CPU board are illuminated, and are
blinking back and forth. This indicates download mode.