WBA
TM
- In Field
Stand-Alone Test Mode
Accomplish this function by applying power to the unit’s
Transport and Head only.
Note: Perform this test outside the game using an
extension harness, or power supply hook-up.
• Remove power.
• Prior to starting, set the Dip switches. Place Dip switches
1,2,3 & 8 in the “ON” position.
• Apply power.
• Turn Dip switch 8 “OFF.” The unit should cycle briefly.
• The unit is now ready for the test.
• Insert a known bill/note.
• The bill/note will either go completely through, or be
rejected.
• If it rejects, check calibration. Re-calibrate if necessary.
If the unit still rejects, there is a possible sensor problem,
or incorrect software version. Go to “Bill Return Tests”
page.
• If it does not take the bill/note in, check for power.
Note: While in this test mode, you can verify if the unit is
working properly.
• When the unit cycles on power up, this indicates power
and forward motor operation.
• When you insert a plain piece of paper and it is rejected,
this indicates reverse motor operation.
• When you insert various denominations of bills, and they
are accepted, this indicates the bill was successfully
matched against the characteristics of the software.
