JCM TSP-01, Инструкция по эксплуатации

Страница: 15 / 26

9. Place the black calibration paper (Part No. 501-000044) in the same position.
10. Close the printer head.
11. Move Dip switch No. 4 to OFF (see Fig. 4)
12. The LED flashes 100 ms ON, 1 sec. OFF (see Fig. 3).
13.Open printer head and remove the black calibration paper.
14.Place the white calibration paper over the barcode and
double-note sensors again.
15.Close the printer head.
16.Move Dip switch No. 1 to OFF (see Fig. 5).
17.Wait until the LED comes on steady, approximately 15
seconds (A blinking LED indicates an error).
18.Open the printer head and remove the white calibration
paper, then close the head.
19.Move Dip switch No. 3 to OFF (see Fig. 6).
20.The LED flashes, 200 ms ON, 200 ms OFF.
21.Turn off the power to the printer.
22.Move all Dip switches to OFF.
LED
Figure 3.
OFF
4 3 2 1
Figure 4
OFF
4 3 2 1
Figure 5
OFF
4 3 2 1
Figure 6
13