JCM TSP-01, Инструкция по эксплуатации

Страница: 14 / 26

Operation
Loading the Paper
1. Fan the pre-cut paper before placing it in
the hopper.
2. Lift the spring-loaded pressure plate.
3. Place the paper stack in the hopper with
the printed side down.
4. Release the pressure plate.
NOTE: The hopper will hold 200 sheets of
pre-cut paper unless the hopper extension has
been added.
5. Replace the printer in the host machine.
Calibration Procedure
1. Make sure the power is turned off or disconnected
from the printer.
2. Put all Dip switches in the ON position (see Fig. 1).
3 Open the printer head by pulling the printer halfway out of
the frame and pulling up on the metal bar.
4. Place the white calibration paper (Part No. 501-000045)
over the barcode and double-note sensors (see Fig. 2).
5. Close the printer head.
6. Apply power to the printer (30 second warm-up delay).
7. The LED flashes, 100 ms ON, 1 sec. OFF (see Fig. 3).
8. Open the printer head and remove the white calibration
paper.
Figure 1
.
Figure 2.
OFF
4 3 2 1
12