jcm-tech RADIOBAND3G, Руководство пользователя

Страница: 20 / 28

Checking and maintenance
Does the equipment work properly?
Once the safety edge is wired and programmed into the receiver, R1 and / or R2
(according to programming mode) is at standby state (off), also IN1 and IN2 at the
transmitter.
If the safety edge has been programmed in R1 and R1 LED is at ON, check that the
safety edge is not pushed/detecting (IN1 LED at ON on the transmitter) or it is not
properly configured (IN1 LED flashing on the transmitter). If IN1 LED is at OFF and
R1 LED is at ON, check status of other transmitters memorized.
The IN1 and IN2 LEDs of the transmitter will pass to battery saving mode (off) 5
minutes after pressing PROG on the transmitter. They can re-awaken again pressing
the PROG button on the transmitter.
If there is no safety edge programmed in R1 and / or R2, it will be in safety mode
(opened and LED at ON)
If R1 / R2 LEDs are at OFF, but the door does not move, check that the wiring to the
control panel is made correctly as safety contact or 8k2 input resistive safety edge.
Total reset
• Press PROG button on the receiver (1) until the R1 LED lights on (2).
• Keep the programming PROG button pressed down and make a bridge with the
“MR” reset jumper (3).
• The receiver will emit 10 warning sound signals (3), and then more at a faster fre-
quency, indicating that the operation has been carried out (4).
• To exit programming mode, wait for 20 seconds or press PROG button on the
receiver. Two beeps will be heard.
jcm technologies
20