jcb JCB-MS-305SB-L, Инструкции и руководство пользователя

Страница: 18 / 29

18
JCB-MS-305SB-L
Instruction & User Manual
• Tighten the set screw (34b) again.
• Move the motor (20) to its upper position.
• Use the handle (1) to push back the motor
(20) and fix it in this position if required
(dependent on the cutting width).
• Retract the lock down pin (22) to release the
motor (20).
• Place the piece of wood to be cut against the
upper fence (14) and on the turn table (26).
• Lock the material with the clamping device
(31) on the base (6) to prevent the material
from moving during the cutting operation.
• Move the Lock - off lever (3) to the left and
press the ON/OFF switch (2) to start the
motor.
With the slide carriage fixed in place:
• Use the handle (1) to move the motor (20)
steadily and with light pressure downwards
until the saw blade (19) has completely cut
through the work piece.
With the slide carriage not fixed in place:
• Pull the motor (20) all the way to the front.
Lower the handle (1) to the very bottom
by applying steady and light downward
pressure. Now push the motor (20) slowly
and steadily to the very back until the saw
blade (19) has completely cut through the
work piece.
• When the cutting operation is completed,
move the motor (20) back to its upper
(home) position and release the ON/ OFF
switch (2).
ATTENTION! The machine executes an
upward stroke automatically due to the return
spring, i.e. do not release the handle (1) after
completing the cut; instead allow the machine
head to move upwards slowly whilst applying
light counter pressure.
Cross cut 90° and turn table 0° (Fig.7.1
)
In the case of cutting widths up to approx.
4” (100mm) it is possible to fix the traction
function of the saw with the slide carriage lock
knob (23) in the rear position. In this position
the machine can be operated in cross cutting
mode. If the cutting width is over 4” (100 mm)
then it is necessary to ensure that the slide
carriage lock knob (23) is loose and the motor
(20) can move.
• Open the set screw (34b) on the moveable
extension block (34a) and push the extension
block (34a) inwards.
• The moveable extension block (34a) must
be locked in a position far enough from the
inner position that the distance between the
extension block (34a) and the saw blade (19)
is no more than 0.3” (8 mm).
• Before making the cut, check that no collision
could occur between the extension block
(34a) and the saw blade (19).
Fig.7.1
7
1
3
2
34a
34b
20
14
6 26