SO53 3LE
Customer Helpline 0845 600 5526 Monday to Friday 09.00 to 17.00
www.JCBdiy.com
COMPONENT LIST AND ASSEMBLY
1. Starter
grip
2. Trigger
release
3. Throttle
trigger
4. Starter
housing
5. Chain lubricant cap
6. Rear
handle
7. Engine
cover
8. Front
handle
9. Front hand guard/chain brake
10. Clutch cover
11. Chain tension dial
12. Clutch cover lock knob
13. Primer bulb
14. Ignition switch
15. Choke lever
16. Fuel cap
17. Flats on drive links
18. Brake position - chainsaw brake
19. Run position - chainsaw brake
20. Silencer
21. Start position
22. Run position
23. Kickbar danger zone
24. Clean the chain brake
25. Idle speed screw “T”
26. Pull
27. Push
28. Rotational kickback
29. Proper hand grip position
30. Improper grip
31. Proper grip
32. Chain line
33. Thumbs on underside of handle bar
34. Straight arm
35. Planned line of fall
36. 135 degree from planned line of fall
37. Path of safe retreat
38. Hinge - 5 cm or 1/10 diameter
39. Back cut
40. Notch approximately 1/3 diameter of
the trunk
41. Hinge
42. Wedge
43. Vertical cut
44. Lodge section
45. Horizontal cut
46. Kickback
47. Log supported at one end
48. Finishing cut
49. Load
50. 1st cut 1/3 diameter
51. Log supported at both ends
52. Overbucking
53. Underbucking
54. Second cut
55. Cut limbs one at a time and leave
support limbs under tree until log is
cut
56. Springpole
57. Chain drive links
58. Cutters
59. Chain rotation
60. Bar groove
61. Adjusting pin
62. Chain tension pin hole
63. Sprocket
64. Rotate clutch cover knob clockwise
to secure
65. Loosen chain
66. Tighten chain
67. Raker (depth gauge) clearance
68. Inspect drive sprocket
69. Gullet
70. Heel
71. Rivet hole
72. Top plate
73. Cutting corner
74. Side plate
COMPONENT LIST
JCB-CS38_Manual_D1.indd 11
JCB-CS38_Manual_D1.indd 11
11/12/2010 6:44:14 PM
11/12/2010 6:44:14 PM
