SO53 3LE
Customer Helpline 0845 600 5526 Monday to Friday 09.00 to 17.00
www.JCBdiy.com
Fuel is highly flammable. Always handle with care.
Always refuel outdoors where there are no sparks and flames. Do not inhale fuel
vapors.
Do not let petrol or lubricant come in contact with your skin. If comes in contact with
your skin, wash immediately with soap and plenty of water.
Keep petrol and lubricant away from your eyes. If petrol or lubricant comes in
contact with your eyes, wash them immediately with clean water. If irritation sill
exists, see a doctor immediately.
Clean up spilled petrol immediately.
1.
TO MIX THE FUEL:
The product is powered by a 2-cycle engine and requires pre-mixing petrol with
2-cycle lubricant. Pre-mix unleaded petrol and 2-cycle engine lubricant in a
clean container approved for petrol.
The engine is certified to operate on unleaded petrol intended for automotive
use with an octane rating of 91 or higher.
Do not use any type of pre-mixed petrol/lubricant from fuel service stations, such
as the pre-mixed petrol/lubricant intended for use in mopeds, motorcycles, etc.
Use high quality 2-cycle self-mixing lubricant for air-cooled engines. Do not use
automotive lubricant or 2-cycle outboard lubricant.
Mix 2% lubricant into the petrol. This is a 50:1 ratio.
1 l
+ 20 ml =
2 l
+ 40 ml =
3 l + 60 ml = 50:1 (2%)
4 l + 80 ml =
5 l + 100 ml =
Mix the fuel thoroughly each time before fueling.
Mix in small quantities. Do not mix quantities more than the amount to use in a
30-day period. A 2-cycle lubricant containing a fuel stabilizer is recommended.
Note:
Fuel system damage or performance problems resulting from the use of an
oxygenated fuel containing more than the percentage of oxygen stated previously
are not covered under warranty.
2.
TO FILL THE TANK:
See Figure 5.
JCB-CS38_Manual_D1.indd 15
JCB-CS38_Manual_D1.indd 15
11/12/2010 6:44:16 PM
11/12/2010 6:44:16 PM
