23
JCB-20BLMS
Instruction & User Manual
m
Tighten the set screw (16b) again.
m
Move the machine head (4) to its upper
position.
m
Use the handle (1) to push back the
machine head (4) and fix it in this position if
required (dependent on the cutting width).
m
Place the piece of wood to be cut at the
stop fence (16) and on the turn table (14).
m
Lock the material with the clamping device
(7) on the fixed saw table (15) to prevent
the material from moving during the cutting
operation.
m
Press the safety interlock lever (3) and press
the ON/OFF switch (2) to start the motor.
With the drag guide (21) fixed in place:
m
use the handle (1) to move the machine
head (4) steadily and with light pressure
downwards until the saw blade (28) has
completely cut through the work piece.
With the drag guide (21) not fixed
in place:
m
• pull the machine head (4) all the way
to the front. Lower the handle (1) to
the very bottom by applying steady and
light downward pressure. Now push the
machine head (4) slowly and steadily to
the very back until the saw blade (28) has
completely cut through the work piece.
m
• When the cutting operation is completed,
move the machine head (4) back to its
upper (home) position and release the ON/
OFF button (2).
Attention!
The machine executes an
upward stroke automatically due to the
return spring, i.e. do not release the handle
(1) after completing the cut; instead allow
the machine head to move upwards slowly
whilst applying light counter pressure
Cross cut 90° and turn table 0° (Fig.7.1)
In the case of cutting widths up to approx.
100mm it is possible to fix the traction function
of the saw with the locking screw (20) in the
rear position. In this position the machine
can be operated in cross cutting mode. If
the cutting width is over 100mm then it is
necessary to ensure that the locking screw (20)
is loose and the machine head (4) can move.
m
Open the set screw (16b) on the moveable
extension block (16a) and retract the
extension block (16a).
m
The moveable extension block (16a) must be
locked in a suitable position far enough away
in the retracted position that the distance
between the extension block (16a) and the
saw blade (28) is no more than 8mm.
m
Before making the cut, check that no
collision could occur between the extension
block (16a) and the saw blade (28).
Fig.7.1
7
14
15
1
2
3
4
16
16a
16b
Fig.8
Fig.9
Fig.10
7
4
11
13
27
14
28