jcb G20, Руководство оператора

Страница: 130 / 177

Maintenance
Fault-Finding
123 9831/0650-3 123
Stop the engine.
Replace the fuel filters. Operate the engine with a
temporary supply of the correct grade of clean fuel.
Fuel is contaminated or incorrect grade diesel fuel
used.
Note: Dirty fuel will cause damage to the fuel injec-
tion pump and injectors.
Inlet and exhaust valve clearances set incorrectly. Set the valve clearances to the recommended clear-
ances. Make sure the push rods are not bent or the
rocker levers are not severely worn.
Turbocharger noise. Check turbocharger impeller and turbine wheel for
housing contact.
Inlet and exhaust valve springs broken. Check and fit new valve springs.
Worn crank/connecting rod bearings (knocking under
load).
Check/replace rod and main bearings.
Excessive camshaft bearing wear. Check bearings (engine overhaul required).
Worn or damaged pistons and/or piston rings. Check piston assemblies (engine overhaul required)
One or more fuel injector worn or malfunctioning. Check the electrical connections at the injectors.
Gear train noise. Visually inspect and measure gear backlash. Re-
place gears as required.
Loss of Pilot injection on one or more cylinders. Use service master to disable pilot injections to iden-
tify audibly if they are still present.
Table 29. Engine - Compression Knocks
Cause Remedy
Fuel is aerated. Check the low pressure fuel system for loose con-
nections and possible air ingress points. Rectify and
bleed the fuel system.
STOP THE ENGINE.
Replace the fuel filters. Operate the engine with a
temporary supply of the correct grade of clean fuel.
Fuel is contaminated or incorrect grade diesel fuel
used.
WARNING: Dirty fuel will cause damage to the fuel
injection pump and injectors.
Electrical sensor fault. Check the electrical connections at the sensors.
Inlet and exhaust valve springs broken. Check and fit new valve springs.
One or more fuel injector worn or malfunctioning. Check the electrical connections at the injectors.
Coolant operating temperature incorrect. Refer to Table 44. and Refer to Table 45.
Table 30. Engine - Reduced Power Output
Cause Remedy
No fuel in supply tank. Check the level in the fuel tank, use sight gauge or
dipstick. Replenish as required.
Oil level incorrect. Check oil level.
Engine overload. Check for added loading from malfunctioning acces-
sories or driven units (alternator).
Throttle position sensor (TPS) system defective. Check the throttle assembly
Stop the engine.
Replace the fuel filters. Operate the engine with a
temporary supply of the correct grade of clean fuel.
Monitor the engine performance.
Fuel is contaminated or incorrect grade diesel fuel
used.
WARNING: Dirty fuel will cause damage to the fuel
injection pump and injectors.
Turbocharger boost control pipe leaking or damaged,
or wastegate diaphragm ruptured
Check boost control pressure. Inspect and tighten fit-
tings, repair pipes, replace wastegate assembly.