JC MACHINERY & TOOLS INC.
Quality We Trust
___________________________________________________________________
www.jc-tool.com [email protected]
iv.
Controller Panel
● ON/OFF switch
（
38
）
is used for open the main power of the welder.
●
Open ON/OFF switch (38), LCD display is shown as figure 1, the hot air blower is under natural
wind without heating.
● Pre
ss the button (37) and (36), the screen shows as Figure 2 and the hot air blower
starts to heat until to the setting temperature.
● If press the bottoms (
37) and (36) at the same time, LCD display shows as figure 1, the hot air
blower is under natural wind without heating.
● When the welding nozzle is at the right position, press the moving switch (
39) and the welder
starts to move and weld. It will stop move if you press the moving switch again.
● When the welder starts to move, the LCD display shows as
figure 3.
●
The knob (40) is used to adjust the air flow of the air gun, increase the air flow by rotating
clockwise, and reduce the air flow by rotating counter-clockwise.
36
33
32
35
37
34
40
39
38
