43
VTX A
8
| Rigging Manual
STEPS:
• With the VT completely secured, lower the array down so that the front wheels of the VT touch the ground. The array should
start to roll backwards slightly and, as the array is lowered, the bottom four boxes will close their inter-enclosure angles and
stop at the 10-degree position.
• Once the bottom four boxes are completely closed together and the gap between cabinets four and five from the bottom is
closed, set all angle selection QRP’s on the bottom four A8 cabinets to the 10-degree STORAGE position.
• Close all eight RED Locking latches.
• Remove the rear QRP’s between the fourth and fifth cabinet from the ground. These QRP’s should move easily, as the weight
of the array is being held by the front wheels of the Vertical Transporter resting on the ground.
• Raise the array back up and allow the four A8 cabinets to roll forward until the cart is resting safely on all four wheels. When
the A8 cabinets on the VT reach this position, stop lifting the array. Remove the front QRP’s and separate the suspended array
from the stacked cabinets on the Vertical Transporter cart.
10.2 - CLOSE THE ANGLE LOCKS AND MOVE PINS TO STORAGE
1
2
3
4
5
1
2
4
3
5
