Appendix C
Harman Consumer Group, Inc.
C-4
the UP or DOWN button, the code number will scroll until your finger
is removed.
8. When the component turns off, press the ON button on the
remote to turn the component back on. Test several functions to
ensure that the component responds correctly to the remote
commands. If any of the buttons do not work properly, you may
not have the right code
–
enter the next code option on your list
until you find the best match for the component.
Note: If you are unable to find a code that will accurately control your
component, then you’ll need to use the Button Learning procedure,
which follows this procedure, to program the component.
9. Once you’ve found the right code, touch the SAVE option on the
touchscreen. The screen will blink “SAVED” two times, indicating
that the code has been successfully saved.
10. Exit the Setup mode by pressing the MAIN button until the
touchscreen displays MAIN in the menu heading area. The remote
control is in normal operation mode again.
11. Repeat Steps 1 through 10 to program all other components in
your home theater system. For any components that do not have
a valid three-digit code, continue to the Button Learning
procedure to program those components.
Recalling Preprogrammed Setup Code Numbers:
In case you didn’t write down the preprogrammed code numbers
that you used when you set up your JBL remote controls, these
three-digit manufacturers’ numbers can be recalled. Perform the
following procedure to recall the preprogrammed three-digit code
for any component.
1. On the remote control, press and hold the MAIN and ENT (Enter)
buttons at the same time. After about three seconds, “SETUP” is
displayed in the Menu name area at the top of the LCD
touchscreen. This is the Setup mode of the remote control.
NOTE: You now have 30 seconds to perform the next step while the
remote is in the Setup mode. If a button is not pressed within 30
seconds, the SETUP menu name will revert to MAIN, indicating that
the remote control is no longer in Setup mode. If this occurs, you will
need to repeat this step to re-enter the Setup mode.
2. Touch the RECAL option. The touch screen now shows a four-page
menu that lists each component name and the three-digit code
that was assigned to it.
3. Write down the code number for each component for future
reference. Appendix D of this manual provides a convenient table
for you to record the three-digit preprogrammed code numbers.
4. Exit the Setup mode by pressing the MAIN button until the
touchscreen displays MAIN in the menu heading area. The remote
control is in normal operation mode again.
Button Learning Procedure for Your Remote Control:
Follow the steps below to set up your AV2 remote control using the
Button Learning procedure. The AV2 remote control can “learn”
commands from other remote controls, both old and new, one button
at a time. Follow the steps below to allow your AV2 remote control to
learn the button commands from other remote controls in your home
theater system.
Note: We recommend that you use this procedure only after you’ve
determined that no three-digit manufacturers’ codes exist for the
component in question.
1. Line up the AV2 remote control with the other remote control,
head-to-head, one or two inches apart.
Содержание AV2
