JBL AV2, Руководство пользователя

Страница: 103 / 134

JBL
®
Performance™ Series AV2 Audio/Video Processor
Appendix C
C-9
If a number is repeated when setting the channel, for example
channel 522, it is usually best to set a half-second delay in
between the identical numbers by pressing the Pause (
||
)
button. Each press of the Pause button increases the delay by
half a second.
7. Press the Light button after you enter the channel number. A new
screen now displays with the options: SAVE, UNDO and EXIT.
8. To save the channel you just entered, touch the SAVE option. The
UNDO option allows you to erase the last entry. The EXIT option
erases all entries for this channel.
9. To set up additional favorite channels, repeat Steps 3 through 6.
10. When finished, exit the Setup mode by pressing the Main button
until the touchscreen displays MAIN in the menu heading area.
The remote control is in normal operation mode again.
Macro Power ON Setup:
Any of the touchscreen menu options can be set up as Macro buttons.
Follow the instructions below to set up a macro button that will power
ON several components at once.
1. On the remote control, press and hold the MAIN and ENT (Enter)
buttons at the same time. After about three seconds, “SETUP” is
displayed in the Menu name area at the top of the LCD touch
screen. This is the Setup mode of the remote control.
NOTE: You now have 30 seconds to perform the next step while the
remote is in the Setup mode. If a button is not pressed within 30
seconds, the SETUP menu name will revert to MAIN, indicating that
the remote control is no longer in Setup mode. If this occurs, you will
need to repeat this step to re-enter the Setup mode.
2. Touch the MACRO option to setup a macro to power ON several
components at the same time. The menu name changes to
“MACRO” and the bottom of the screen flashes “SELECT”.
3. Press the ON button. The menu name changes to “P-ON” and the
bottom of the touchscreen flashes “STEP 0”, indicating that no
macro steps have been entered yet.
4. Touch a component option that you want the macro to turn ON.
Use the menu page arrows to navigate to the other menu pages, if
required. The menu name changes to the name of the component
option that you touched and the bottom of the screen now flashes
“STEP 1”.
5. Press the ON button again to confirm the action. The Step
Indicator now displays “STEP 2”.
Note: The Step Indicator is a macro step counter. Every button that is
pressed will increase the Step Indicator by one. Each macro can store
up to 190 steps.
6. Press the Main button to return to the Main component listing.
7. Repeat Steps 4 through 6 until all of the components that you
want to power ON at once have been added to the macro.
Note: If desired, you can also program delays into the macro between
the commands, by pressing the Pause (
||
) button. Each press adds half
a second to the delay.
8. When all of the components have been added to the macro, press
the Light button. The menu name changes to “MACRO” as a new
screen is displayed with the options: SAVE, UNDO and EXIT.
9. To save the macro you just entered, touch the SAVE option. The
UNDO option allows you to erase the last step. The EXIT option
erases all steps for the macro.
10. When finished, exit the Setup mode by pressing the Main button
until the touch screen displays MAIN in the menu heading area.
The remote control is in normal operation mode again.
Note: There is no touch screen menu listing for the macro you just
saved. However, when you press the ON button on the remote for one
of the included components, MACRO is displayed in the bottom of the
touchscreen area.