JBL AV2, Руководство пользователя

Страница: 104 / 134

Appendix C
Harman Consumer Group, Inc.
C-10
Macro Power OFF Setup:
To create a macro which will turn OFF several components at the same
time, just follow the same steps as listed above, but press the OFF
button instead of the ON button.
Macro Using Component Button Setup:
To setup a macro to use a component, in Step 2 of the procedure
above, after pressing MACRO, press the page
button twice. The
menu name changes to MAIN. Touch the component option that you
want to set as the macro button. You can navigate to page 2 if
necessary. Now continue in the procedure to Step 3 and follow the rest
of the procedure to completion.
Setting a “Press and Hold” Macro:
Another option for the component button macros is to only send the
macro if the component button is held down. The advantage of this
option is that a normal press of the component button will simply
switch components without triggering the macro. Only holding down
the component button will trigger the macro.
To set the “Press and Hold” macro, enter a delay as the first step of the
macro by pressing the Pause (
||
) button. Each press adds half a second
to the delay. The amount of delay determines how long the user must
hold down the button before the macro is sent.
Cloning other JBL AV2 Remote Controls:
If you happen to own more than one AV2 remote control, you can
copy and transfer the setup from one remote to the other. Follow the
instructions below to clone your AV2 remote control.
1. On both the programmed remote control and the remote that
you want to program, press and hold the MAIN and ENT (Enter)
buttons at the same time. After about three seconds, “SETUP” is
displayed in the Menu name area at the top of the LCD
touchscreen. This is the Setup mode of the remote control.
NOTE: You now have 30 seconds to perform the next step while the
remote is in the Setup mode. If a button is not pressed within 30
seconds, the SETUP menu name will revert to MAIN, indicating that
the remote control is no longer in Setup mode. If this occurs, you will
need to repeat this step to re-enter the Setup mode.
2. Touch the CLONE button on both remotes. The menu name
changes to “CLONE” and the bottom of the screen flashes
“SELECT BUTTON”. A new screen now displays with the options:
SEND, RECV and EXIT.
Touching the EXIT option will leave the menu without making
any changes or triggering the cloning process.
3. Line up the “master” remote control with the “slave” remote
control, head-to-head, one or two inches apart.
4. On the “slave” remote, touch the RECV option. The SEND/RECV
options are replaced with “START” and the bottom of the
touchscreen flashes “PRESS START”.
5. On the “master” remote, touch the SEND option. The SEND/RECV
options are replaced with “START” and the bottom of the
touchscreen flashes “PRESS START”.
6. First on the “slave” remote and then on the ”master” remote,
touch the START option to begin the cloning process.
Note: Cloning typically takes about 40 seconds. After a successful
cloning is complete, the newly cloned remote will flash “GOOD”.
7. When finished, exit the Setup mode by pressing the MAIN button
until the touchscreen displays MAIN in the menu heading area.
The remote control is in normal operation mode again.
Setting System Volume Control and Other Punch Throughs:
The AV2 remote control provides the option of setting up the volume
control over all of the components in your home theater system, even
with components that don’t have their own built-in volume controls,
such as TiVo®. This is a very powerful feature as, once it’s set up, it will