JBG HT ZHHS-01-10K-R290-V5-M, Руководство по обслуживанию

Страница: 18 / 32

18
© JBG-HT (v.2.0)
SERVICE MANUAL – HEAT PUMP
Min : minimum value of the DHW set temperature that
can be set
Max : maximum value of the DHW set temperature
that can be set
Fixed Req : the set control value for the circulating
pump expressed as a percentage (if the control type
is Fixed Speed)
Min : minimum circulating pump control value for
automatic control
Max : maximum control value for circulating pump for
automatic control
Regulation type : selection of the operation mode of
the circulation pump in DHW mode:
• Fixed speed – constant flow speed
• Cond temp – speed depending on the con-
densation temperature
Alarm source : selection between whether the alarm
is to operate according to the Setpoint offset or
Temp. level rules.
Setpoint offset : the difference between the setpoint
temperature and the measured temperature above
which the cold water alarm will occur
Temp. level : water temperature below which the cold
water alarm will occur
Startup : the time after the start of the control in which
the fulfillment of the alarm condition does not cause
the alarm to occur
Run : the time value for which the alarm condition
must be met to trigger the alarm
Enable Mode : operation mode of the circulation
pump:
OFF – turned off
Sched. ECO – ECO mode linked to the calendar
Sched. ON – operation mode linked to the calendar
ECO – ECO mode
Always ON – always on
Pump state : - signaling operation of the circulation
pump
ECO ON Time : time duration of operating in ECO
mode
ECO OFF TIME : time duration of standby in ECO
mode