1
2
18
Note:
The chamfered side has
to be positioned towards the
handle.
2. Mounting Position
3. Inserting Sealing Plug
1. Removing Sealing Plug
Push the sealing plug inside
the handle until the sealing
plug and handle edges are
aligned.
Introduce a small shaft or
screwdriver, not deeper than
8 mm, lift and pull the sealing
plug. Never use a cartridge to
do this operation.
Handle
Chamfered
Side
Tool Holder Dissasembly and Replacement
Adjustable tool holders can be disassembled by
loosening the screws (1) at the bottom of the charging
base and pulling downward from the side band (2).
Before sliding down the side band, hold the tool
holder with your hand to prevent it from falling down.
Then, to install a new tool holder onto the charging
stand, place the tool holder at the top of the side rail
and slide back the slide band over it until it is secured
in place and tighten the screws at the base.
Find more information about Expansion Kits on
www.jbctools.com.
Side Band
