JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein phone: +49 7304 9617-0
www.jb-lighting.de
- 22 -
3.2.3 Switching banks of fixture group faders
There are 8 fixture group faders available. They can be switched four times. To select one of the
four banks press shift key and simultaneously one of the flash keys located below the fixture
faders. The LED will mark the activated bank
3.3 The Highlight function
The Highlight/Group key has two functions. It helps locating fixtures and it is used to activate fixture groups
To activate fixture goups press the highlight key once. The LED must be lit. Then use the flashkeys which
are located underneath the fixture fader to activate on of the groups. Make sure that the masterfader and the
groupfader is positioned at full.
To locate fixtures:
Press simultaneously Group/Highlight key and one of the keys in Fixture/Par-Selection
The fixture will open shutter and show a white beam.
To switch off the highlight function press the flashing LED of the fixture-key twice
Caution:
A beam is only visible when the fixture is assigned to a fixture group and the fixture group fader is positioned
full.
3.4 How to program fixtures by means of encoder wheels
Activate fixtures by pressing fixture keys (LED has to be lit). Or use group key and fixture
group flash keys. Make sure master fader and fixture group faders are positioned at
100%.
Select parameter from the Feature-Selection section.
Use encoder wheels to enter DMX values.
For visible control always place master fader and fixture group fader at full!!!!
3.4.1 Postitioning in 16bit
If the configuration of the fixtures allows 8bit and 16bit mode adjustment can be done like this: Activate
fixture first. Recall feature PAN/TILT and use the encoder wheel which is located in the middle to adjust 8bit
or 16bit mode.
8bit:
FINE OFF (000-255)
16bit
FINE ON (000-65535)
