Jayco JAY SPORT 2018, Руководство пользователя

Страница: 80 / 145

Section 6: Electrical System
72
Command Center Panel
Command Center Panel
W/Switch Modules
GFCI Receptacle
There is a ground fault current interrupter (GFCI) engineered into the electrical system. It is
designed to reduce the possible injury caused by electric shock. The GFCI will not protect
against short circuits or circuit overloads.
NOTE: If your RV model includes the 5 way/8 way remote control:
the LIGHT button on the remote only controls the awning LED lights.
the RV, and contains switches and controls for various electrical
functions. Command center applications, configurations and
components will vary by model.
Command Center Panel or Command Center Panel with
Switch Modules
Items found on these panels may include:
Fuel gauge and hour meter with switches for fuel pump and
fuel levels; fuel station (if so equipped) on/off switch
Lighted red pump and water heater switches (electric & LP
gas)
Generator start / stop switch; may include hour meter
Tank heater switchesLight switches for porch lights, exterior
security lights, interior lights, awning LED lights, front cap
LED accent lights, power entry step
Cargo bed red lighted control switch
Slideout control switches (press and hold to extend / retract)
Awning control switches (press and hold to extend / retract)
Systems monitor with LED indicators for tank levels and
battery charge status
Auto leveling control panel (for leveling the RV)
Inverter panel (power switch with display)
Power bunk bed lift control switch
Speaker selector switch
Command Center Modules Mounted to the Wall
Some models may have the modules mounted directly to the interior
wall of the vehicle. They are typically located near the entrance
door.Touch Dimmer Switch:
Certain models may include a touch dimmer switch next to the
Command Center panel. (There are no interior light switches on
the Command Center panel).
Turn ON ceiling lights: Tap the LED light on the dimmer
Turn OFF ceiling lights: Tap the LED light on the dimmer
Dimmer: If lights are off, hold finger on the LED light and lights will
begin turning on gradually until fully lit. If lights are on, hold finger
on the LED light and lights begin to gradually turn off.
The dimmer has a memory so it remembers what the light setting was when
the lights were turned OFF. When turned ON again, the lights return to that
same setting.
Table of Contents Maintenance Record