Jayco JAY SPORT 2018, Руководство пользователя

Страница: 72 / 145

Section 4: Vehicle Operation
64
5.
Pull out the telescoping side arms. Pull the canopy flaps
over the front and side rails and at the corners.
NOTE:
tilting the vertical legs in slightly will make it easier to pull
the flaps down at the corners. Secure the end of the side
arm into the top holder on the side of the unit
(Fig. 5a),
making sure the side arm snap buttons lock into place
(Fig
5b).
The side arm(s) should be extended so the canopy
fabric is tight, but not tight enough to pull or stretch the
fabric. If the side arms start to bow as you raise the unit,
STOP IMMEDIATELY
and adjust the canopy.
6.
Pull down the side flaps at the unit and place the end of the awning cover over the end
(Fig. 6a)
. Zip the canopy cover until you reach the end of the side flap
(Fig. 6b)
. This
will help direct the water run-off from the canopy.
7. Secure all canopy legs by installing tent stakes next to each leg so that the “hook” on
the stake is inserted into the hole on the foot.
NOTE: If also installing a
screen room, wait until that
set up is complete to do
Steps 7 & 8.
Over tightening the canopy may result in
excessive wear or tearing of the fabric at seams,
at corners or where the canopy is attached to the
unit.

NOTE: If your canopy has a center post, insert the post into the
hole in the center of the main rail.
Table of Contents Maintenance Record