Jayco Designer 27 RKS, Руководство пользователя

Страница: 45 / 115

34
3. Pour the solution (water/bleach) into the tank and fill the tank with potable water.
4. Open all faucets (Hot and Cold) allowing the water to run until the distinct odor of
chlorine is detected.
5. The standard solution must have four (4) hours of contact time to disinfect com-
pletely. Doubling the solution concentration allows for contact time of one (1) hour.
6. When the contact time is completed, drain the tank. Refill with potable water and
purge the plumbing of all sanitizing solution.
NOTE: The sanitizing procedure outlined above is in conformance with the approved
procedures of RVIA ANSI A119.2 and the U.S. Public Health Service.
If there is a problem of excessive chlorine odor and taste after the sanitizing process,
follow the above procedures using a solution of baking soda (1/2 cup added to one gallon
(4 liters) of water per 15 gallons (60 liters) of tank capacity) or vinegar (one quart added
to five gallons (20 liters) of water per 15 gallons (60 liters) of tank capacity.)
Your demand water system is now ready for use.
Definition of the Utility Center Label Terms (Fig. 4-6)
Normal – This setting allows you to pump water from the fresh water tank to all faucets
when you are not hooked up to city water. Turn on your 12-volt demand pump to
accomplish this.
City Water – This setting allows you to have access to water at all faucets on demand.
Connect a garden hose from an outside water source to the city water connection inlet at
the utility center and turn on your outside water.
City Tank Fill – This setting allows you to fill your fresh water tank. Connect a garden
hose from an outside water source to the city water connection inlet at the utility center.
Open the faucets inside the trailer to bleed air from the lines, and turn on your outside
water.
Country Tank Fill – This setting allows you to fill your fresh water tank with water from
an outside tank. Connect a garden hose to the city water connection at the utility center;
put the other end of the hose in the outside water tank, and turn on your 12-volt demand
pump.
Sanitize Tank – (See the instructions in the following section.)
Antifreeze/Sanitize Lines – (See the instructions in the “Winterizing Units with Utility
Centers” in this manual.)