25
Operations (Electric Slideout)
EXTENDING ROOM
1. Batteries must be fully charged and connected. The travel
trailer should be hooked up to 120-volt AC power if pos-
sible.
2. The travel trailer must be level and the stabilizer jacks in the
down position.
CAUTION:
Additional support jacks are not needed under
the slideout. Damage can occur to your slideout room from
improper use of support jacks.
3.
For Eagle and Qwest models, remove the “travel bars”
(Fig. 3-5) from behind the top facia board located above slideout room.
4. Locate slideout room control switch.
5. To move room out, press the “OUT” button on switch (Fig. 3-7) and hold until
motor stops. Release button. Travel time – approximately twenty-five seconds.
RETRACTING ROOM
1. Remove all objects left between the slideout and cabinetry.
2. Press the “IN” button to bring room in and hold until motor stops.
3. Release button.
4.
For Eagle and Qwest models, install “travel bars” (Fig. 3-5) in proper locations
as indicated on the wall.
CAUTION: IMPORTANT! Never store slideout without the travel bars installed on
the Eagle and Qwest models. This helps seal the slideout in the closed position.
Troubleshooting Electric Slideout
If the slideout does not move when the slideout switch is depressed, follow these steps.
1. Check the battery for full charge and good wire connections.
2. Check for loose connections at the slideout motor.
If slideout still will not operate, follow these steps.
1. If the slideout is extended, see the section on overriding the electric slideout system.
2. If the slideout is retracted, leave it in that position. (On Eagle and Qwest models,
install the “travel bars.”)
3. Take the trailer to the nearest dealer or service center.
If the slideout extends crooked, or only one side moves, follow these steps.
1. Follow steps 1 & 2 in the section on overriding the slideout system to disconnect the
motor.
2. Retract slideout using the hand crank. You may need to push the side that is not
sliding to get it to retract all the way.
3. Once the slideout is fully retracted, install the “travel bars” on the Eagle and Qwest
models.
4. Take your travel trailer to nearest dealer or service center.
Fig. 3-7
Содержание Designer 27 RKS
