Jayco 2016 White Hawk, Руководство пользователя

Страница: 65 / 150

JAYCO TOWABLE SECTION 5 – SLIDE-OUT SYSTEMS
5-7

If the slideout extends crooked or only one side moves, follow these steps.

Follow steps on overriding the specific slideout system installed on your RV.

You may need to push the side that is not sliding to get it to retract all the way.

Contact your dealer or customer service for repair assistance.
Manual Operation for the flush floor slideout
The electric slide comes with a manual over ride system. Locate the crank extension under
the inside of the frame (refer to Fig. 1 and 2).
This is where the crank handle (standard fifth wheel landing gear crank handle or 3/4”
socket and ratchet fits on to allow the manual extension/retraction of the room (Fig. 3 and
4). Simply take the wrench, ratchet or drill with a nut driver and rotate it clockwise to
retract and counterclockwise to extend slide-out.
It is important to note that you DO NOT need to attempt to disengage the motor as the
actuator is “manual ready” Just hook up and crank.
Use EXTREME CAUTION when extending and/or retracting room using the manual
override feature. It is possible to operate the slideout beyond the maximum extension
and/or retraction and damage the slide components, slide room structure or trim
components.
MANUAL OPERATION - THROUGH FRAME
Fig. 1-Through Frame Crank Fig. 2- Crank Handle
Extension w/ pin
MANUAL OPERATION - IN FRAME
Fig. 3-Hex Head Crank Extension Fig. 4-Ratchet
CAUTION
Always disconnect battery from system prior to manually operating system. Failure to
disconnect battery can cause electricity to backfeed through the motor and cause
serious damage to the system as well as void the warranty