Jayco 2016 White Hawk, Руководство пользователя

Страница: 61 / 150

JAYCO TOWABLE SECTION 5 – SLIDE-OUT SYSTEMS
5-3
1. The auxiliary battery (customer supplied) must be fully charged and connected.
If possible, the recreation vehicle should be hooked up to 120-volt AC power so
the converter operates.
2. The recreation vehicle must be level and the stabilizer jacks in the extended
position.
3. Slideout switches are typically located on the inside of the recreation vehicle,
either in the command center panel or on the wall. To move the room out, press
the OUT section of the switch and hold it until the motor stops (travel time is
approx. 25 seconds).
Operating the switch after the room is fully extended
will damage the switch and motor .
Some models may be equipped with a wireless remote control to operate the slideout.
To operate the slideout using the remote, press the on/off button to power on the
remote. Select the slideout you want to operate by pressing the corresponding button.
Next, press and hold the (extend/retract) arrow button to move the room in or out.
When you are finished moving the slideout,, press the on/off button once more to
power off the remote. DO NOT try and time the end of the stroke by releasing the
button early. ALWAYS allow the controller to stop both motors before releasing the
switch button.

NOTE: Do not operate the switch after the room is fully extended as damage can
occur to the motor and/or switch.
Retracting slideout room
Press the IN section of the slideout control switch and hold it until the motor stops.
Operating the switch after the room is fully retracted will damage the switch and motor.
Maintenance
Your slideout system has been designed to require very little maintenance. To ensure a
long life of your slideout system, read, understand and follow these simple instructions.
This system contains a pre-lubed bearing that is lubricated when the room is moved in and
out. Do not spray oil or grease on the rails while the room is extended.
Trouble shooting the Inwall slideout system
Checking Fuses:
The inwall slide requires a minimum 30 Amp fuse. Check the load
center for blown fuses and replace any if necessary. If the fuse blows immediately upon
replacement, there is a problem with the wiring to the inwall slide control box. A qualified
service person should be called to check and repair.
Obstructions:
Check outside the recreation vehicle for possible obstructions such as a tree, post or car
etc. Check inside the vehicle for any obstructions such as luggage, furniture or open
cabinets etc. Also check for smaller objects that may be wedged under the floor or in the
sides of the unit. Remove any obstructions before proceeding.
Error Codes:
Refer to error codes explained previously along with instructions on how to locate the
inwall slide controller.
WARNING
Do not work on your system unless the 12-volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical systems (shore line power cord) have been
disconnected.