Jayco 2016 White Hawk, Руководство пользователя

Страница: 57 / 150

JAYCO TOWABLE SECTION 4 – VEHICLE OPERATION
4-11 WHTT
Raising and lowering the hoist
In most cases the crank handle to raise and lower the tire will be
located in a basement compartment of the recreation vehicle.
Typically, it is fastened to the sidewall of the compartment. Insert the
crank handle into the crank access port located either in the center of
the rear bumper, or in the sidewall of the RV. Turn the crank handle
to lower the tire, or to lift into the travel position. Two “crisp breaks”
must be heard and felt to insure the proper seating of the tire for travel.

NOTE: If the manual crank access port is located in a slideout, the
slideout room must be in the travel position. If the slideout is extended the crank will not
reach the mechanism to raise or lower the tire.
Securing the spare tire
To secure the spare tire in the travel position, put the steel hoist lift support located on the
end of the cable through the rim of the tire. The hoist lift support clips need to seat inside
the center hole of the tire rim. The valve stem of the tire MUST be pointed in the up
position or toward the bottom of the RV. Reverse this process to release the spare tire for
usage.
Bumper mount
The spare tire bracket can be released and extended down to access a storage compartment
at the rear of the trailer without removing the tire.
To extend the tire down
1. Remove the cotter key from the pin holding the tire carrier
in place.
2. Remove the pin and extend the tire carrier away from the
trailer.
3. Always return the tire carrier to the upright position and lock
it in place while traveling.
To remove the tire from the tire carrier
1. Remove the lug nuts holding the tire in place.
2. Remove the support bracket from the bottom lug.
3. Pull the tire from the tire carrier.
Bumper mount
To install the tire on the tire carrier
1. Place the tire on the carrier with the top lug bolt inserted into one of the holes in the
tire rim and the bottom lug bolt in the center of the rim.
2. Install the top lug nut.
3. Place the support bracket over the bottom lug bolt across the center of the rim.
4. Install the bottom lug nut over the support bracket.
5. Make sure the lug nuts are tightened securely before returning to travel.
Crank access
port