Jay electronique ISIS Series, Инструкция по установке и эксплуатации для пользователя

Страница: 83 / 156

- 83 -
ISIS
- 331260D
revision02
DE FR EN
7.3- Wiring the products
7.3.1- Wiring recommendations
• Use control components with integrated interference suppression system.
• Do not place cables of different classes side by side.
• A minimum space (20 cm) should be observed between the different classes:
-
Classe 1 :
Radio, antenna cable (case of an antenna extension),
-
Classe 2 :
Mains for power supply of various units,
-
Classe 3 :
Power control for motors, variable speed drive, etc...
Ideally, each cable class should be run through a cable path
speci fi c to the cable. If only one cable path is available, the cables
of different classes should be separated as much as possible.
7.3.2- Terminal strips
If fl exible stranded wire is used, crimped terminations should be
used to avoid false contacts and short circuits.
To open the connection terminal strips:
- Vertically insert the screwdriver ( fl at tip screwdriver
of 1.5 to 3 mm width) in the slot located opposite
the wire,
- Insert the wire,
- Remove the screwdriver.
Do not apply any lever movement to the
screwdriver as this can result in damage to
the terminal strip and the printed circuit on
the motherboard.
To avoid any risk of electrocution, do not open the
receiver or transceiver unit when powered up.