Configuration
Configuring the Internal GSM Module
Configuring the GSM module for Internet access
46
www.javad.com
3.1.2. Configuring the GSM module for Internet access
Note:
To comply with RF exposure requirements, maintain at least 20 cm between the user and the
GSM modem.
1. On the General tab, set the following parameters (Table 3-3) and click Apply (Figure 3-5
on page 46). In this tab modem and service status and possible errors are displayed.
Table 3-3. Receiver Parameters for the General Tab
Figure 3-5. General tab
2. In the GPRS tab it is necessary to set the dial number, user name and password, access
point name and PDP context identifier to establish a GPRS connection. As usually, this
information is given by cell provider (Figure 3-6 on page 47).
PPP button opens the PPP parameters window, that allows user to set up the Point-to-Point
protocol parameters. The Point-to-Point Protocol, or PPP, is commonly used to establish a
direct connection between two nodes.
As usually, information of PPP parameters is given by Internet service provider.
Parameter
Base Receiver
Rover Receiver
Mode
GPRS
PIN
Enter a Personal Identification Number (PIN) if required.
