Safety Warnings
Power Supply
107
www.javad.com
Warning:
Do not short circuit the battery pack.
Warning:
Do not crush or modify the battery pack.
Power Supply
Connect the supplied adapter to the side of the unit in the slot marked “PWR”. Plug the two-prong
end of the power cord to an AC100-240V outlet.
If you have difficulty inserting the plug, turn it over and reinsert it. If the unit will not the used for
a long time, disconnect the plug from the outlet.
Note:
Before plugging the power cord into an AC outlet, make sure that all the connections have been
made.
C
AUTION
:
To reduce the risk of electric shock, do not perform any servicing other than that contained in
the operating instructions unless you are qualified to do so.
C
AUTION
:
To avoid the introduction of hazards when operating and installing, before connecting of the
equipment to the supply, make sure that the supply meets local and national safety ordi-
nances and matches the equipment’s voltage and current requirements.
C
AUTION
:
Never attempt any maintenance or cleaning of the supply while plugged in. Always remove
supply from AC power before attempting service or cleaning.
Warning:
If the voltage supplied is below the minimum specification, the receiver will suspend
operation. If the voltage supplied is above the maximum specification, the receiver may
be permanently damaged, voiding your warranty.
Make sure cords are located so that will not be stepped on, tripped over, or otherwise subjected to
damage or stress. Do not operate equipment with a damaged cord or plug – replace immediately.
To reduce the risk of damage to the equipment, pull by the plug body rather than the output cord
when disconnecting the equipment.
Do not operate the supply if it has received a sharp blow, been dropped, or otherwise damaged. Do
not disassemble the supply.
Warning:
Before connecting the external power source and the receiver, make sure that the
power source matches the receiver’s voltage and current requirements.
