CSE Stacking/Mobility Kit Assembly
(Sold Separately)
5.
For Additional Support Call: 866.393.4202 or Email: [email protected]
INSTALLING CASTERS
1. Place the unit on its side. Make sure the locks are engaged
on all four casters. Secure each caster to the bottom using
four bolts per caster.
(A)
INSTALLING HANDLE
1. Pick which side of the unit you want to install the handle on
and remove the two small black caps from that side Squeeze
the sides of the cap and push it out at the same time. Leave
the two small black caps on the other side in the unit.
(B)
2. Slide the removable covers on either side of the handle to be
able to locate the holes for the screws.
3. Align the handle over the holes, reach inside the unit with one
hand holding the bolt and Allen wrench and stick the bolt up
though the bottom. With the other hand, thread the nut onto
the bolt down to the two guides in the plastic handle to hold
the bolt in place as it is tightened eliminating the need for a
wrench, and tighten the bolt from below.
(C)
4. Slide the removable covers back on either side of the handle
to finish installing the handle.
NOTE:
If you plan to stack two
units, install the handle on the top unit.
STACKING TWO CHARGING STATIONS
1. Remove the black caps from the four larger holes in the top
of the bottom unit. Squeeze the sides of the cap and push it
out at the same time.
(D)
2. Place the second unit on it’s side and insert the four rubber
feet if they are not already installed.
3. Place the second unit on top of the first unit. Line up the
holes in the bottom side of the top unit with the four larger
holes in the top side of the bottom unit.
4. Insert the stacking screws into the holes from inside of the
bottom unit. Screw in all four partially at first and, when they
are all in, tighten them the rest of the way.
(E)
A
E
D
C
B
