Japan Subcontract APM-N90, Руководство пользователя

Страница: 9 / 55

7
3.4 DIP Switch Setting
Set each function of the printer by DIP switches on the board inside the case.
Contents set by DIP switches will be valid when turned on or Reset is input from
outside.
Please follow the process below.
①
Turn of the printer.
②
Depending on the interface that you selected on purchasing, it is set to
Parallel or serial.
When you want to change it, please use sharp-point thing such as driver to
Set DIP switch. Don’t apply too strong force on DIP switches, or it may
damage the switches. See the table below about DIP switch setting.
Here DIP switch setting has finished.
If turned on, the printer operates with the specified contents.*
1
Table 3-1 : Functions and Setting Contents of DIP Switches
No. Functions ON Side OFF Side
1 Kanji Code Shift JIS Shift JIS
2
3 Baud Rate Selection See Table 3-2
4
5 Print Density
Selection*
2
See Table 3-3
6 Print Mode Selection*
3
HEX Printing Normal Printing
7 Head Mode Selection*
4
- Normal Printing
8 Check Mode*
5
Test Mode Normal Printing
*1 : APM-N90 is set to be initialized on power supply turning on or by inputting outside reset to read
setting of DIP Switch. So even if you change the switch during use, the contents of setting will not be
changed.
*2 : Print density can be changed by the control code DC2+S+n.
*3: Printing the input data with HEX, keep ON>
*4 : Only for customize switch. Keep OFF usually.
*5 : Check Mode for shipping inspection. Keep OFF usually.