49
DC2 + “m” + s + n1 + n2: Detect the mark position
HEX:12h + 6Dh + s + n1 + n2
DEC:18 + 109 + s + n1 + n2
Feed the paper until it detects the mark.
s: Detection sensor, feeding way, stop condition
Second lower 2 bit is effective.
Bit Function 0 1
0 bit Stop condition mark no mark
1 bit Feeding way forward backward
Define the line number with n1(lower byte) +n2(upper byte).
0
≦
n1n2
≦
4095
Set the length to the mark detection by the number of the line and it can’t detected
with the higher set value it would be paper error.
( If it is set as no paper error, is won’t be error. If it is set as no mark, the paper would
be feed only the default value.)
・
HTPN can’t use backward feeding.
DIP SW Set
1. Kanji Code default value
ON Shift JIS
OFF JIS Code
2
・
3 Serial communication baut rate
2
3
OFF OFF 96000BPS
ON OFF 4800BPS
OFF ON 19200BPS
ON ON Auto set. Available to set from 2400BPS to 19200BPS.
Send the following command when start communication.
$$$$$$$$$$$$
＊
(24H
＊
12 2AH
＊
1 Put 2AH at the last )
When sending this command, set 2400BPS ~ 19200BPS.
＊
Notice) Send the command for check after more than 100ms.
4
・
5 Correction of the printing density
4 5
OFF OFF normal density
ON OFF 130%
