Janschitz Milky 13360, Инструкция по эксплуатации

Страница: 23 / 40

23
MAINTENANCE AND TROUBLESHOOTING
If error code „Er2“ or „Er3“ is written on display and pasteurizer does not work, disconnect
the pasteurizator from mains and call the authorised service - do not repair it yourself.
In case that in secondary coat is not enough water or that temperature of secondary wa-
ter rises over 100 °C the security switch switches off all functions on the device. (overhea-
ting protection). In this case you have to reread the manual and use the product properly.
The mistake must be removed – usually this happens when there is not enough secondary
water in the pasteurizer. When this happens, thermostat must be manually deactivated
before further use. Make sure you disconnect the device from power supply before deacti-
vating the thermostat.
CLEANING
• Before cleaning make sure that the pasteurizer is switched off and disconnected from
main power supply.
• Before cleaning make sure that the pasteurizer is cooled down.
• The milk pot and the cover should be cleaned with hot water adding fat soluble deter-
gents. Afterwards these parts should be rinsed with pure water.
• The pasteurizer shall be cleaned only with wet cloth and afterwards dried with dry cloth.
• Do not use abrasive materials to avoid scratches.
• After use ALWAYS clean the pot. Do not use aggressive detergent.
• If milk or cream rests get dry do not remove them with sharp objects or sharp duster.
ENSURE THAT NO WATER COMES INTO CONTACT WITH ELECTRONICS AND ELECT-
RONIC PARTS.
PLEASE NOTE!
BEFORE CLEANING YOU MUST ALWAYS DISCONNECT DEVICE FROM ELECTRICITY.